Reflective Trailer Tape Ontario CMVSS 108

Stay on the Road and Out of the Out-of-Service Bay

An MTO roadside stop or CVSA inspection is not the moment to discover your trailer is missing compliant conspicuity tape. DOT-C2 trailer conspicuity tape Canada fleets depend on — sized by the roll, certified to the standard, and stocked for same-week shipping across Ontario.

What You Get

Alternating red and white DOT-C2 reflective segments on a pressure-sensitive backing, cut-ready and sized to standard trailer lengths. Available in 25 ft, 50 ft, and 150 ft rolls — no partial rolls, no waste, no guesswork on quantity.

• DOT-C2 grade reflective sheeting with permanent embossed certification markings accepted under Transport Canada Technical Standards Document (TSD) 108
• Roll lengths matched to cover one or both sides of a standard 53-foot trailer to the required 50% side-coverage threshold
• Aggressive adhesive bonds to aluminium, steel, and fibreglass trailer surfaces without primer on clean substrates
• Made in Canada — printed and cut on Canadian equipment, shipped from Ontario stock

How It Works

CMVSS 108 requires trailers over 4,536 kg GVWR to carry conspicuity tape covering at least 50% of the trailer's side length and the full rear width. The calculation is straightforward: measure your trailer's side rail length, multiply by 0.5, and that's the minimum linear footage required per side. A single 50 ft roll handles one side of most 53-foot trailers; a 150 ft roll covers both sides and the rear with material to spare.

• Clean the surface with isopropyl alcohol and allow to dry completely before application
• Apply tape to the lower half of the trailer side — between 375 mm and 1,525 mm from the ground — for full CMVSS 108 placement compliance
• Overlap and trim at ribs or structural breaks; inspectors measure coverage percentage, not tape continuity
• No heat gun or primer required on most metal and fibreglass surfaces

Why It Works

Generic reflective tape and DOT-C2 tape look similar in the roll. The difference shows up at inspection. DOT-C2 tape carries a permanent embossed certification mark visible every 300 mm along its length — the mark an MTO or CVSA inspector checks to confirm the material meets the standard, not just the colour. Tape without that mark can trigger a defect notice even when it appears reflective on the surface.

• DOT-C2 is the specific grade required under CMVSS 108 — not DOT-C1, not unmarked reflective film
• Non-compliance carries substantial fines under the Highway Traffic Act and can result in an out-of-service order that pulls a trailer from revenue service on the spot
• Recognised by CVSA inspectors at Ontario ports of entry and roadside check stops — not just technically compliant on paper
• Priced per roll so fleet managers can stock and budget by trailer count without tracking remnants or partial cuts

Choose your roll size below and get compliant conspicuity tape shipped to your yard or shop this week.